When you use Spooky2, you can use the following methods to ensure that your Spooky2 is working properly.
Generator-XM & -GX
The screen will light up when working with XM or GX. If you want to ensure that the generator sends out the frequency, we recommend using the remote control to run a signal test. If the LED on the remote control flashes normally, the signal source is working. You can search for “Signal Test” in the “Presets” tab to find a test preset (see screenshot below).
Remote control
When using remote controllers with different frequencies, you may notice differences in their LEDs. The LED may flicker, stay on, look dim, or even don’t look bright. All of these can indicate that the function is normal, because the frequency, waveform and amplitude together control the way the LED responds to the signal. Low amplitude will dim or turn off the light, and when the frequency is high, the LED flashes too fast for your eyes to catch and it seems to stay on.
Boost
Connect your remote control to Boost. If the remote control works normally, then your Boost should be fine. The light will go out only when you connect PEMF to Boost.
Contact
Whether you can feel any sensations in the contact mode depends on the program. When the program is at high frequency or low voltage, you may not feel anything. If you are not sure whether your contact mode is valid, you can run a signal test. Most people will feel the current.
Plasma
If you want to check if your plasma is working, you just need to connect it correctly, load a program, and see if the inside of the plasma tube lights up and flickers. As long as the lamp is turned on and blinking, it is working.
