The reason why there’s a hole in the middle of Spooky2 Coil is that it gives the ability to implant frequencies into liquids. The hole is the right size for vials (small glass containers) to slide in. The idea is that people put medicine, tinctures, or even water, into a test tube or small container and place it in the coil which is resting flat on a table. They then run treatment frequencies on the contents of the bottle. After a while they stop the generator and drink the contents of the bottle. People think this is a good way of getting frequencies into the body. They use frequencies that they would otherwise use on themselves.
1. connect the PEMF coil to the out1 port of the generator.
2. put the liquid to be imprinted into the PEMF coil. For example, if you want to engrave a glass of water, you can put a glass of water on the PEMF coil, and the BN surface should face the glass.
3. open the Spooky2 software, go to the “Presets” tab, and click “Shell (empty) presets/weird coils (direct generator)-JW”. Go to the Program tab, for example, if you want to press the Schumann frequency into the water, you can search for “Schumann” here and then select Schumann resonance.
Note: We recommend that the total count of the rehabilitation programs you run is less than 8.
4. go to the “Control” tab, check “Overwrite generator”, then select the generator port, click “Start” to start printing, wait for a day or two, you can drink water at the Schumann frequency. You can also put medicines and tints into test tubes or small containers, and then place them in a coil that lies flat on the table.
5. Please note that high frequencies should recombine the water within an hour or two, while low frequencies such as Schumann resonance may take a day or two.
The following video will show you how to use PEMF coil to imprint frequency.
